Conversion Kit Instructions

Converting your Envirolet from one power type to another is easy!


Removing the current Panel...
1. Carefully break the silicone seal on the outside edge of the Top Panel on your Envirolet System using a small knife.

2. Unscrew the screws on the Top Panel using a #2 Robertson drill bit.

3. Remove the Top Panel and Blower Pipe you are replacing. If applicable, remove the electric WID Box and Blower Pipe from the Top Panel opening.


Adding the new Panel...
1. Insert the electric WID Box, with Blower Pipe attached, into the Top Panel opening.
* Make sure that the open "grid" is facing you when standing in front of the system. This is to ensure that the Vent Fan is lined up on the left hand side under the vent opening on the Top Panel. Try to set the WID Box so that is rests as evenly as possible in the Top Panel opening.

2. Place Top Panel on top of WID Box.
* Make sure that the vent opening on the Top Panel is on the left hand side when you are standing in front of the system.

3. Attach the Top Panel using #8 x 1" screws provided using #2 Robertson drill bit. Add screws in pre-drilled holes on plastic Top Panel.

4. Re-apply silicone sealant around the entire Top Panel between the panel and the body of the Envirolet System.




Removing the current Panel...
1. Unscrew the screws on the Top Panel using a #2 Robertson drill bit.

2. Remove the Top Panel and Blower Pipe you are replacing. If applicable, remove the electric WID Box and Blower Pipe from the Top Panel opening.

Adding the new Panel...
1. Insert the electric WID Box, with Blower Pipe attached, into the Top Panel opening.
* Make sure that the open "grid" is facing you when standing in front of the system. This is to ensure that the Vent Fan is lined up on the left hand side under the vent opening on the Top Panel.

2. Replace black Gasket Seal, located around Top Panel opening, if required.

3. Place Top Panel over WID Box.
* Make sure that the vent opening on the Top Panel is on the left hand side when you are standing in front of the system.

4. Attach the Top Panel using #8 x 2" screws provided using #2 Robertson drill bit. Try to line up so new screws match up with the previous screw holes.
* Make sure that the Top Panel is sealed securely with the black Gasket Seal.

If you have any questions or require assistance, please do not hesitate to call our customert service dept. (M-F, 8:30am to 4:00pm EST).

Winter Sale













CONTACT US
info@sancorindustries.com | USA Toll-Free 1-800-387-5126 | Canada Toll-Free 1-800-387-5245 | Help Desk
Please visit our contact page for more info.

INTERNATIONAL SITES
Please visit either CANADA | EUROPE | UK | JAPAN


Copyright © 2018, Sancor Industries Ltd. All rights reserved. Envirolet®, envirolet.com© and envirolet.ca© are registered trademarks of Sancor Industries Ltd. Sancor™, Envirolet® VF™, VF™, FlushSmart™, EnviroletCare™, Automatic Six-Way Aeration™ and Works-in-a-Drawer™ are trademarks of Sancor Industries Ltd.